by Ancient Order » Mon Mar 07, 2022 11:04 pm
These things have GOT to get outta my builds. I've looked around a little but can't seem to find a decent replacement other than the Glock OEM standard release. I've seen where some people have just cut the extended one down and did various things like smoothing, stippling, grooving. But I'd really like to have one that sits lower but has a bigger pad that comes closer to the rear because my thumb doesn't quite reach comfortably. Any ideas?
by Hawkeye » Sat Mar 12, 2022 6:41 pm
OK I did a right up in resources if you want to check it out. It's not as hard as it sounds, I only scraped one Tyrant mag release, that is where I learned that the modifying the cannel in the mag release has to be the same size as the original slot, if not it fits to tight because its in a bind from the spring tension.