by sailman » Wed May 11, 2022 11:49 am
My son has a G17 that he recently built and it was running pretty good with with aftermarket trigger parts. We went to the gun show a couple weeks ago and he a Apex tactical trigger group and installed it in the gun. The gun was running and operating fine before he changed out some parts. Here's a list of what he changed, Rook rear rails, Apex tactical trigger, Apex trigger bar, Apex tactical connector. And these are his words not mine I think you will find it funny, And that thing in the bottom of the slide that has the tiny Spring in it by Apex tactical. I think hes talking about the Firing pin safety plunger Spring. So now when you cycle the slide and pull the trigger the firing pin falls, when you cycle the slide again without your finger on the trigger it will reset reset but if you do not take your finger off of the trigger it will not reset when you do you do if that makes sense. I took the gun apart last night and pulled the trigger assembly out and and adjusted the connector but but when I did this I noticed that the connector was loose in the slot that it goes in could this be causing the issue? I don't believe the trigger housing is a stock glock part. I don't have any pictures at the moment but I can get some up later tonight.
by sailman » Sat May 14, 2022 5:37 pm
I've already got on him about this. You can believe that I did the safety check before he got it back.