by Ancient Order » Wed Jul 27, 2022 7:02 pm
I can't believe ANOTHER build with the same issue: not getting 2/3 coverage on the seer/striker lug. Every build I've done except one comes in at only about 1/3 coverage. OEM parts, non-OEM, doesn't seem to matter. The one build that was good has full coverage. Go figure. I should tear that one down, but I can't remember which one it was! This current build has ZP Slide/barrel, OEM trigger housing, LW 3.5 connector, Rook rails/locking block, ZP striker assy, OEM trigger bar, RP Hybrid Ranger shoe. Pin holes are perfect, pins slip right in. Very little slop in the slide. Swapped in OEM striker - same deal. I can't believe that I should have to bend the seer on every build, and can't figure out if I'm doing something wrong. I always strive for FTQ. At this point, all I can think of is the connector. It might be the geometry of the 3.5 (-) connector, which is what I always use because I don't like the feel of the standard connector. So I guess I'll swap in an OEM std connector and see if there's a difference. If anybody's run across this issue and knows why, PLEASE tell me!!
by RAMjetta » Mon Aug 01, 2022 8:15 pm
Glad you fixed the issue. I too would want to know what caused the problem.
JettaMan OUT!