by Ancient Order » Tue Aug 02, 2022 8:17 pm
Has anybody else run across this issue? I think my Dremel HS 17/64 bit may be slightly over sized. It makes great holes, but the trigger pin is very loose. Unfortunately, I drilled 4 frames before checking the fit. As long as the slide release catches the groove in the pin, it seems ok, but has a tendency to walk if not.
by Hawkeye » Wed Aug 03, 2022 5:39 pm
This is why I started drilling holes under size and then open them up to size using a bit in a hand vise. With the bits that came with a fame, it gave me a bad wobble too, so now I do the under-size holes, so I have more control. It takes me longer, but I get straight polished holes every time.