by sailman » Sun Jun 19, 2022 6:00 pm
OK I'll start with what I have found so far. My son brought over AG23 build that he is working on it's a polymer 80 frame with a Patmos slide upper. He brought it over stating that it would not feed a around in the chamber. And of course it's not fitty one thing that I did find when trying to troubleshoot was troubleshoot was that the firing pin seems to stick out, sometimes and sometimes it doesn't. I took the firing pin and the firing pin safety plunger out of the gun and polished it pushed it this did not help the issue. Then I took the firing pin back apart and slid it down into the channel liner and could not easily get it to come out of the firing pin hole. I am thinking that there is some type of abstract obstruction in there but I cannot see it went up shine the light down the hole. What are some possible fixes? Also with it not clambering a round I did take the extractor out and it chambers a dummy round just fine so I'm assuming that it needs a new extractor is this correct?
This is just from racking the slide and checking the sear engagement a few times.
I just got to look at this picture after posting it, this is a 40 caliber gun if I am not mistaken what is in it is a 9 mm ejector. Am I correct in saying this?
by sailman » Tue Jun 21, 2022 3:51 pm My son picked up his lower frame today and took it home and put his G19 slide onto this frame and it fits like a glove so I just think that we may have had an out of speck slide.